JazPiper+ Family Karaoke Soundbar

with Smart Voice

User manual

Control Panel
Key # Short Press Long Press (3 sec)
1 Power ON/Power OFF
2 Mute sound, Play/Pause (in USB/BT mode) Change source
3 Previous Song (in USB/Bluetooth mode) Master Vol -
4 Next Song (in USB/Bluetooth mode) Master Vol +
5 Mic Vol -
6 Mic Vol +

Speaker Connections

* this controls are application
dependent
Key #

Function
Power Power On / Stand-By
ModeChange input source
Mute Mute / Unmute Speaker
Prev/FBW Previous Song / Fast Backward
Play/Pause Play / Pause
Next/FFW Next Song / Fast Forward
Youtube Voice MuteMute original voice for Youtube Video
Ctrl PanelControl panel for microphone sound effect
Key +Increase music key *
Key -Lower music key *
Home Go to home
VocalChange vocal/voice effect
Setup For network setup, etc...
OKSelect
Move selection
Menu Menu
Voice Voice input control
Back Back to previous option
Mic +Increase microphone volume
Mic -Lower microphone volume
Mouse Change remote control to mouse mode
Vol +Increase master volume
Vol -Lower master volume
PausePause the Song *
NextSwitch to next song *
ApplauseActivate Applause
BooActivate Booing
ListSee the list of selected songs *
Echo +Increase echo (in Echo mode)
Echo -Lower echo (in Echo mode)
Treble +Increase treble level
Treble -Lower treble level
Bass +Increase bass level
Bass -Lower bass level
Reserved
Reserved
Reserved
Reserved

Setting up the soundbar
  1. Connect the power adapter from your power outlet to the JazPiper+.
  2. Connect the HDMI cable from your JazPiper+ to your TV.
  3. Flip the power switch behind your JazPiper+ to ON and turn on with the remote control or by holding down the power button on the top side of the device.
  4. Connect to the internet with either Wi-Fi or ethernet cable*
  5. Turn ON the Power Switch at the back of the soundbar, and Power ON using the Remote Control or the Power Button.
  6. The soundbar will boot up in about 1 minute, and ready to use
*Ethernet cable is not provided

Connect JazPiper+ to the internet via Wi-Fi
  1. From the home page, go to [Setting] by selecting the button.
  2. Go to [Network & Internet].
  3. Find your Wi-Fi name and enter your Wi-Fi password.
Setting up the remote for voice command input
To enable voice input, you will need to pair the Remote Control to the Soundbar. Below are the steps:
  1. Hold down the and buttons at the same time until the remote LED starts blinking.
  2. Goto [Setting] >> [Bluetooth] >> [Toggle Bluetooth Enable] >> [Pair new device].
  3. Select “JP Voice Remote”
*Note* When not in use, please remove the batteries from the Remote Control and Microphone to prevent battery leakage which will damage the devices, and will void the warranty.
COPYRIGHT © 2024 JAZPIPER. ALL RIGHTS RESERVED.
Scroll to Top